Santa Fe V6-3.5L (2004)
b. Fix the lock pin in place by staking two points around the lock pin hole with a punch.
7. Installation of the drive gear
a. Clean the drive gear attaching bolts.
b. Remove the adhesive on the threaded holes of the drive gear use a tap (M10 1.25), and then clean the threaded holes with compressed air.
c. Apply the specified adhesive to the threaded holes of the drive gear.
d. Install the drive gear in the differential case with the matchmarks properly aligned. Tighten the bolts to the specified torque (800 - 900 kgf-cm)
in a diagonal sequence.
8. Press the side bearing inner race
ADJUSTMENT OF FINAL DRIVE GEAR BACKLASH
Adjust the final drive gear backlash according to the following procedures:
1. Install side bearing spacers which are thinner than those removed, to the side bearing outer races, and then mount the differential case assembly
into the gear carrier.
