Santa Fe V6-3.5L (2004)
10.
Refer to the DTC recorded in Step 1 and replace the related solenoid according to the diagram shown. Tighten the bolts to 4-5 lb.ft (50-70 kg.cm).
Go to Step 11.
NOTE:
^
P0743 - TCC solenoid open/short
^
P0746 - VFS solenoid performance
^
P0748 - VFS solenoid open/short
^
P0750 - LR solenoid open/short
^
P0755 - UD solenoid open/short
^
P0760 - 2nd solenoid open/short
^
P0765 - OD solenoid open/short
^
P0770 - RED solenoid open/short
11.
Apply Permatex Ultra Gray Sealer or Hyundai Ultra Gray Gasket Sealer, P/N 00231-13800 to the valve body cover and reinstall the cover.
Tighten the bolts to 6-7 lb.ft (80-100 kg.cm).
12.
Add approximately five quarts of Hyundai SPIII ATF and check the level with the engine idling in Neutral. Recheck the ATF level when the ATF
is at normal operating temperature (70-100°C, 159-212°F).
13.
Clear the codes and test drive the vehicle for two driving cycles (two key-on to key-off driving cycles, including 1-2-3-4 upshifts and 4-3-2-1
downshifts). If the DTC returns, perform the repairs shown.
