Santa Fe FWD L4-2.4L (2010)
Brake Hose/Line: Service and Repair
Repair Procedures
Removal
1. Remove the wheel & tire.
2. Remove the brake hose clip (A).
3. Disconnect the brake tube by loosening the tube flare nut (A).
Tightening torque
: 12.7 - 16.7 Nm (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)
4. Disconnect the brake hose (A) from the brake caliper by loosening the bolt.
Tightening torque
: 16.7 - 25.5 Nm (1.6 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
Installation
1. Installation is the reverse of removal.
CAUTION:
Use a new washer (A) whenever installing.
2. After installation, bleed the brake system