Santa Fe FWD L4-2.4L (2010)
8. Remove the cylinder head cover (A).
9. Remove the air compressor lower bolts.
10. Remove the air compressor bracket (A).
11. Drain the engine oil.
12. Remove the oil pan (A). Insert the blade of SST (09215-3C000) between the ladder frame and oil pan. Cut off applied sealer and remove the lower
oil pan.
NOTE:
-
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
-
After tapping the SST with a plastic hammer along the direction of arrow around more than 2/3 edge of the oil pan, remove it from the ladder
frame.
-
Do not use the SST as a prybar. Hold the tool in position (on gasket line) and tap in with a light hammer.
-
Be careful not to damage the contact surfaces of ladder frame and lower oil pan.
