Santa Fe FWD L4-2.4L (2010)
Tightening torque:
M6: 7.84 - 9.8N.m (0.8 - 1.0kgf.m, 5.8 - 7.2lb-ft)
M8: 18.6 - 22.5N.m (1.9 - 2.3kgf.m, 13.7 - 16.6lb-ft)
CAUTION:
Running the engine or performing a pressure test should not be performed within 30 minutes of assembly.
11. Install the engine support bracket (C).
Tightening torque:
M10 : 39.2 - 44.1N.m(4.0 - 4.5kgf.m, 28.9 - 32.5lb-ft)
M8 : 19.6 - 24.5N.m(2.0 - 2.5kgf.m, 14.5 - 18.1lb-ft)
12. Install the crankshaft pulley (B).
Tightening torque :
166.6 - 176.4N.m (17.0 - 18.0kgf.m, 122.9 - 130.1lb-ft)
NOTE:
Use the SST(flywheel stopper, 09231-3K000) to install the crankshaft pulley bolt, after removes the starter.
13. Install the water pump pulley (A).
Tightening torque :
7.8 - 9.8N.m (0.8 - 1.0kgf.m, 5.8 - 7.2lb-ft)
14. Install the drive belt tensioner (B) and tensioner pulley.
Tightening torque :
53.9 - 63.7N.m (5.5 - 6.5kgf.m, 39.7 - 47.0lb-ft)
15. Install the idler pulley (A).
Tightening torque :
53.9 - 63.7N.m (5.5 - 6.5kgf.m, 39.7 - 47.0lb-ft)
