Santa Fe FWD L4-2.4L (2010)
CAUTION:
Tensioner pulley bolt is left - handed screw.
16. Install the air compressor bracket (A).
Tightening torque :
19.6 - 23.5N.m (2.0 - 2.4kgf.m, 13.7 - 14.5lb-ft)
17. Install the compressor lower bolts.
Tightening torque :
19.6 - 24.5N.m (2.0 - 2.5kgf.m, 13.7 - 18.1lb-ft)
18. Install the drive belt (A).
Crankshaft pulley -> A/C pulley -> Alternator pulley -> Idler pulley-> P/S pump pulley -> Idler pulley -> Water pump pulley -> Tensioner pulley.
Rotate the auto tensioner counter - clockwise. With the tensioner turned, install the drive belt on auto tensioner and then release the tensioner.
19. Install the engine mounting bracket (A) and connect the ground cable.
Tightening torque :
Bolts (B) & Nut (C) :
63.8 - 83.4 N.m (6.5 - 8.5 kgf.m, 47.0 - 61.5 lb-ft)
Nut (D) :
78.5 - 107.9 N.m (8.0 - 11.0 kgf.m, 57.9 - 79.6 lb-ft)
20. Install the oil pan.