Santa Fe FWD L4-2.4L (2010)
Instrument Cluster / Carrier: Service and Repair
Crash Pad
Replacement
Cluster Replacement
NOTE:
-
When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
-
Put on gloves to protect your hands.
1. Tilt the steering column down.
2. After disconnecting the trip sensor connector (A), remove the cluster facia panel (B).
3. Installation is the reverse the removal.
4. Loosen the screws.
5. Remove the cluster (A).
6. Disconnect the cluster connector (A), then remove the cluster (B).
7. Installation is the reverse of removal.
NOTE:
-
Make sure the connector are plugged in properly.
