Santa Fe FWD L4-2.4L (2010)
Oil Filter: Service and Repair
Oil And Filter Replacement
CAUTION:
-
Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis.
In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
-
Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your
skin thoroughly with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
-
In order to preserve the environment, used oil and used oil filter must be disposed of only at designated disposal sites.
1. Park the car on level ground.
Start the engine and let it warm up.
2. Drain engine oil.
(1) Remove the oil filler cap.
(2) After lifting the car, remove the oil drain plug (A) and drain oil into a container.
3. Replace the oil filter (B).
(1) Remove the oil filter.
(2) Check and clean the oil filter installation surface.
(3) Check the part number of the new oil filter is as same as old one.
(4) Apply clean engine oil to the gasket of a new oil filter.
(5) Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(6) Tighten it with the torque below.
Tightening torque :
11.8 - 15.7N.m (1.2 - 1.6kgf.m, 8.7 - 11.6lb-ft)
4. Install the oil drain bolt with a new gasket.
Tightening torque :
34.3 - 44.1N.m (3.5 - 4.5kgf.m, 25.3 - 32.5lb-ft)
5. Fill with new engine oil, after removing the engine oil level gauge.
Capacity :
Total : 5.5 L (5.8 US qt, 4.8 lmp qt)
Oil pan : 4.2 L (4.4 US qt, 3.7 lmp qt)
Drain and refill including oil filter :
4.6 L (4.9 US qt, 4.0 lmp qt)
6. Install the oil filler cap.
7. Start engine and check for oil leaks and check the oil gauge or light for an indication of oil pressure.
8. Recheck the engine oil level.
