Santa Fe FWD L4-2.4L (2010)
Crankshaft Position Sensor: Service and Repair
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the crankshaft position sensor connector (A).
3. Remove the protector (A).
4. Remove the installation bolt (A), and then remove the crankshaft position sensor.
Installation
CAUTION:
-
Install the component with the specified torques.
-
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
CAUTION:
-
Apply the engine oil to the O-ring.
CAUTION:
-
Insert the sensor in the installation hole and be careful not to damage when installation.
1. Installation is reverse of removal.
Crankshaft position sensor installation bolt:9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M8):18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)
Crankshaft position sensor protector installation bolt (M6):9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
