Santa Fe FWD L4-2.4L (2010)
Shift Solenoid: Service and Repair
Removal
1. Remove the battery and the battery tray.
2. Remove the under cover (A).
3. Replace new gasket and the plug after drining the automatic transaxle fluid by removing the drain plug.
4. Remove the valve body cover (A) and eyebolt (B).
Tightening torque:
(A) 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
(B) 34.3 - 44.1 N.m (3.5 - 4.5 kgf.m, 25.3 - 32.6 lb-ft)
CAUTION:
The gasket of the eyebolt use new one.
NOTE:
Remove installation bolts in the engine room first and then remove others under the vehicle.
5. Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
6. Remove the solenoid valve (A) after removing the solenoid support.