Santa Fe FWD L4-2.4L (2010)
Impact Sensor: Service and Repair
Side Impact Sensor (SIS)
Components and Components Location
Components
Repair procedures
Removal
Front Side Impact Sensor
CAUTION:
-
Removal of the airbag must be performed according to the precautions/procedures described previously.
-
Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
-
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the front door trim.
3. Disconnect the Side Impact Sensor connector and remove the Side Impact Sensor mounting bolt.
Rear Side Impact Sensor
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the rear seat.
