Santa Fe FWD L4-2.4L (2010)
NOTE:
Remove the rear assist arm ball joint (A) by using the special tool(09568-4A000).
CAUTION:
If the bush is excessive worn and damaged, replace the assist arm assembly.
Installation
1. Install the rear assist arm (A) to the rear carrier.
Tightening torque :
Bolt(B) : 137.3 - 156.9N.m (14 - 16kgf.m, 101.3 - 115.7lb-ft)
Nut(C) : 98.1 - 117.7N.m (10.0 - 12.0kgf.m, 72.3 - 86.8lb-ft)
NOTE:
After checking the distance(465±10mm(18.31±0.39in)) between the wheel housing garnish (A) and the hub assembly (B) as shown in the
illustration, tighten the mounting bolts and nuts of rear chassis part with specified torque.
2. Install the wheel and tire (A) to the rear hub (B).
Tightening torque :
88.3 - 107.9N.m (9 - 11kgf.m, 65.1 - 79.6lb-ft)
