Santa Fe FWD L4-2.4L (2010)
36. Install the torque converter. Rotate the converter while pushing inward and upward until the converter is fully seated within the case.
Depth: 9/16~5/8 (14~16mm)
37. Install the transaxle in the reverse order of removal.
38. Apply M0S2-400 grease (Petroleum grease with Molybdenum Disulfide), P/N 00232-19048 or equivalent to the splines on the passenger side
intermediate shaft and also on the splines in the transmission. Install the axle shaft.
39. Attach the radiator hoses and add ethylene glycol engine coolant to the radiator. Check the level according to the Santa Fe Shop Manual, "Engine
Section".
40. Remove the overflow/fill plug. Use a suction gun or equivalent to add PH-IV to the overflow plug until oil flows out in a thin oil stream.
NOTE:
Collect and dispose of any excess fluid in accordance with local regulation.