Santa Fe FWD L4-2.4L (2010)
CAUTION:
-
Before disassembling flange, mark the alignment point.
-
It is to assemble with alignment, when you reassemble flange.
5. If center bearing do not fall, lightly hit the center bearing as shown in the illustration. Then, center bearing(A) is disassembly.
CAUTION:
-
When you hit strongly, appear the abrasion in the shape of the screw thread.
6. Installation is the reverse order of removal.
Universal joint disassembly
1. After marking alignment point on flange yoke and tube yoke, disassemble snap ring(B) on tube yoke.
CAUTION:
-
The alignment point assembles in the direction on marked reassemble.
-
It is to minimize the change of balance.
2. Disassemble the case(A) by using hammer as shown in the illustration.
