Santa Fe FWD L4-2.4L (2010)
6. Install the driveshaft to the axle hub.
7. Install the lower arm mounting bolt (B) and the split pin to the knuckle (A).
Tightening torque :
98.1 - 117.7 Nm (10 - 12 kgf-m, 72.3 - 86.8 lb-ft)
8. Install the tie rod end ball joint (C) to the knuckle (D).
9. Install the castle nut (B) and the split pin (A).
Tightening torque :
23.5 - 33.3 Nm (2.4 - 3.4 kgf-m, 17.4 - 24.6 lb-ft)
10. Install the brake caliper (B) and then tighten the mounting bolts (A).
Tightening torque :
78.5 - 98.1 Nm (8 - 10 kgf-m, 57.9 - 72.3 lb-ft)
11. Install the washer (C), castle nut (B) and split pin (A) to the front hub assembly.
Tightening torque :
196.1 - 255.0 Nm (20 - 26 kgf-m, 144.7 - 188.1 lb-ft)
