Santa Fe FWD L4-2.4L (2010)
2. Remove the both boot clamps from the transaxle side PTJ case.
(1) Using a flat-tipped (-) screwdriver, remove the both clamps of the transaxle side.
3. Pull out the boot from the transaxle side joint(PTJ).
4. Remove the clip (C) from the PTJ case (B).
5. While dividing joint(PTJ) boot (A) of the transaxle side, wipe the grease in PTJ case (B) and collect them respectively.
CAUTION:
-
Be careful not to damage the boot.
-
According to below the illustrated, put marks (D) on roller of trunion assembly (A), PTJ case (B) and spline part (C), for providing assembly.
6. Using a snap ring plier or flat-tipped (-) screwdriver, remove the circlip (A).