Santa Fe FWD L4-2.4L (2010)
12. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is
removed.
13. Separate the dynamic damper (A) from the shaft (B) carefully.
14. Using a plier or flat-tipped (-) screwdriver, remove the clamp on the side of wheel.
15. Pull out the joint(BJ) on the side of wheel into the transaxle direction.
Be careful not to damage the boot.
Reassembly
Reassembly
1. Wrap tape around the driveshaft splines (PTJ. side) to prevent damage to the boots.
2. Apply grease to the driveshaft and install the BJ boots.
3. Install the bands to both BJ boots.
4. Using the SST(09495-3K000), secure the boot bands.
Clearance (A): 2.0 mm (0.079 in.) or less