Santa Fe FWD V6-2.7L (2007)
3.
Using both hands, simultaneously press and hold both the desired HomeLink button and the hand held transmitter button.
DO NOT release until the HomeLink indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be
released. The rapid flashing indicates successful training and the procedure is complete. This also indicates that the garage door opener does not
use rolling code technology.
NOTE:
The garage door may open or close during this step.
Steps 4 through 7 are only necessary if the HomeLink button appears to be transmitting after step 3, but the garage door does not operate.
4.
Press and hold the trained HomeLink button and observe the indicator light. If the indicator light is solid/continuous, training is complete and your
device should activate when the HomeLink button is pressed and released.
If the indicator light blinks rapidly for 2 seconds and then turns a solid/continuous light, proceed with the following training instructions for a
rolling code device. A second person may make the following steps quicker and easier. It is recommended that a ladder or similar device be used
to obtain access to the motor housing. Do not stand on the vehicle to perform the next steps.
5.
At the garage door opener receiver (motor housing) in the garage, locate the "learn" or "smart" button (usually near the hanging antenna wire
attached to the unit). If there is difficulty locating the training button, refer to the garage door opener's manual.
6.
Press and release the "learn" or "smart" button (the name and color of the button may vary by manufacturer).
NOTE:
Once the button is pressed, there are 30 seconds in which to initiate the next step.
7.
Return to the vehicle and firmly press and hold the trained HomeLink button for two seconds and release. Repeat the "press/hold/release"
sequence up to 3 times to complete the training process. If successful, your garage door should open or close during this step.
If the vehicle owner continues to have difficulty programming their HomeLink mirror, please have them contact HomeLink customer service
directly at 1-800-355-3515 or www.homelink.com for further assistance.
