Santa Fe FWD V6-2.7L (2007)
WARRANTY INFORMATION
Technical Service Bulletin # 07-99-001
Date: 070101
Paint - Cloudy Appearance
Group: PAINT
Number: 07-99-001
Date: JANUARY, 2007
Model:
ALL
Subject:
CLOUDED PAINT CORRECTIVE PROCEDURE
DESCRIPTION:
This TSB updates TSB 00-99-001.
Hyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants
such as rail dust, acid rain, and industrial fallout. In rare cases the paint can become clouded under the PPF. These spots are the result of moisture
trapped between the PPF and the paint.
CLOUDED PAINT SPOT REMOVAL PROCEDURE:
1.
Remove all PPF from vehicle.
2.
Clean the vehicle. If the spots are still visible, use an infrared light, similar to the type used in a body shop, to heat the affected area. Most infrared
lights can be set up about 2 feet from the paint surface to achieve a hot surface temperature, depending on the heat output. Do not let the paint
temperature exceed 180°F. Be careful not to allow nearby trim to overheat (above 180°F).
3.
Allow the infrared light to heat the vehicle for a minimum of 15 minutes, a maximum of 3 hours. Check the vehicle every 15 minutes to ensure it is
not overly hot. You should be able to briefly touch the heated area, but it should be uncomfortably hot.
ADDITIONAL COMMENTS:
Small spots can be removed with a heat gun. Hold the heat gun about 12-18 inches from the spot, keeping it moving. Do not let the paint
temperature exceed 180°F.
Heating for 10 to 15 minutes should remove the spot. If the spot persists after 15 minutes, switch to the procedure mentioned above.
Wiping the spot with undiluted alcohol will accelerate the drying. Wipe a rag with the alcohol across the area before heating. Do not apply cool
