Santa Fe FWD V6-2.7L (2007)
2) Check the part number of a new oil filter is as the same as that of the old one.
3) Replace the oil filter.
4) Tighten it slightly until the O-ring of the filter cap contacting on its position.
5) Tighten it with the specified torque.
Tightening torque 16.7-24.5Nm(l.7-2.5kgf.m, 12.3-18.1 lb-ft)
5. Refill with engine oil.
1) Install the oil drain plug with a new gasket.
Tightening torque 34.3-44.1 Nm (3.5-4.5kgf.m, 2 5.3-32.5 lb-ft)
2) Fill with fresh engine oil, after removing the engine oil level gauge.
Capacity
Total: 4.5L(4.76U.S.qts,3.96 Imp.qts)
Oil pan 4.2L(4.44U.S.qts,3.70 Imp.qts)
Oil filter 0.3L(0.32 U.S. qts,0.26 Imp.qts)
3) Install the oil filler cap and the oil level gauge.
6. Start the engine and ensure that no oil is leaking from the drain plug or the oil filter.
7. Recheck engine oil level.