Santa Fe FWD V6-2.7L (2007)
10. Remove the intake manifold assembly(A).
INSTALLATION
1. Install the intake manifold assembly with a new gasket to a cylinder head assembly. Tighten the bolts in two steps.
CAUTION: When installing the gasket on the cylinder head, check the identification marks (LH/RH) not to be installed wrong.
2. Install the delivery pipe.
3. Connect the LH injector connector.
4. Install the surge tank.
Tightening torque 18.6-23.5Nm (1.9-2.4kgf.m, 13.7-17.4lb-ft)
5. Install the surge tank mounting bracket.
Tightening torque 18.6-23.5Nm (1.9-2.4kgf.m, 13.7-17.4 lb-ft)
6. Install the ETC(Electronic Throttle Control) system fixing bracket.
7. Connect the hoses and connectors.
8. Install the air cleaner assembly.
9. Install the engine cover.
