Santa Fe FWD V6-2.7L (2007)
5. Install the timing belt.
Crankshaft sprocket(A)->Idler(B)->Bank 2 exhaust camsprocket(C)->Water pump pulley(D)->Bank 1 exhaust camsprocket(E)->Tensioner
pulley(F).
6. Remove the auto tensioner set-pin.
7. Check the tension of the timing belt.
1) Turn the crankshaft 2 rev. clockwise which makes the No.1 cylinder piston position at TDC. After 5 minutes, measure the length of the
projected rod.
2) Ensure the locations of the timing marks for each sprocket.
8. Install the engine support bracket(A).
