Santa Fe FWD V6-2.7L (2007)
Oil Filter: Service and Repair
SELECTION OF ENGINE OIL
Recommended API classification: Above SJ or SL
Recommended SAE viscosity grades: 5W-20
NOTE: For best performance and maximum protection of all types of operation, select only those lubricants which
^
Satisfy the requirement of the API classification.
^
Have proper SAE grade number for expected ambient temperature range.
Lubricants that do not have both an SAE grade number and API service classification on the container should not be used.
REPLACEMENT OIL AND FILTER
CAUTION:
^
Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and
dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
^
Wear protective clothing and gloves in order to minimize the length and frequency of contact of your skin to used oil. Wash your skin
thoroughly with soap and water, or use water-loss hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
^
In order to preserve environment used oil or used off filter must be disposed only at designated disposal sites.
1. Park the car on a level ground.
Start the engine and let it warm up.
2. Turn the engine off.
3. Drain engine oil.
1) Remove the oil filler cap.
2) After lifting the car, remove the oil drain plug(A) and drain oil into a container.
4. Replace the oil filter.
1) Remove the oil filter(B).
