Santa Fe FWD V6-2.7L (2007)
5.
Remove the lower strut mounting bolts and pull the knuckle away from the strut.
Front strut assembly mounting bolt (to knuckle) torque:
15.5 - 17.5 kgf-m (112.1 - 126.6 lb-ft.).
6.
Pull the CV shaft out of the knuckle/hub assembly by pushing down on the knuckle/lower control arm assembly and sliding the CV shaft out.
7.
Remove any foreign material from the surface between the front hub (G) and the driveshaft (H) with a clean cloth.
8.
Clean the newly supplied plastic washer and apply grease to the washer as shown in the picture. This will keep the washer in place during
re-installation.
NOTE:
Be careful not to apply excessive amounts of grease in this area. Grease is only used to keep the washer in place during re-installation.