Santa Fe FWD V6-2.7L (2007)
9.
Center the washer on the front hub, with its surface where grease has been applied facing the front hub, and then fix it to the front hub.
10.
Repeat steps 1 through 8 on the other side and install all the removed parts in reverse order of removal.
NOTE:
When installing the driveshaft to the front hub, be careful not to allow the washer to move.
NOTE:
Discard used/removed cotter pin and replace with a new one. Do not reuse removed cotter pins during the re-installation process.
PART INFORMATION
WARRANTY INFORMATION