Santa Fe FWD V6-2.7L (2007)
Fail-Safe Mode
FAIL-SAFE MODE
COMPONENT INSPECTION
THROTTLE POSITION SENSOR (TPS)
1. Connect a scantool on Diagnosis Link Connector (DLC).
2. Start engine and check output voltages of TPS 1 and 2 at C.T and W.O.T.
3. Turn ignition switch OFF and disconnect the scantool from the DLC.
4. Disconnect ETC module connector and measure resistance between ETC module terminals 4 and 1 (TPS 1..
5. Measure resistance between ETC module terminals 7 and 6 (TPS 2..