Santa Fe FWD V6-2.7L (2007)
4. Enter the Event password from the table below and then select OK.
5. If voltage is below 12 volts, then select Cancel and run the engine at idle for at least
10 minutes to ensure an adequate battery charge state for reliable update results.
6. Updating will occur until 100% is reached on the bar graph, then the confirmation screen will be displayed. Turn the ignition key OFF for 10
seconds, place it back in the ON position and then select OK.
7. Select OK on the final screen, which indicates update is complete.
8. Check if any incidental Diagnostic Trouble Codes (DTC) have been created by the update and clear the DTC (5) present.
9. Start the engine to confirm proper operation of the vehicle.
