Santa Fe FWD V6-2.7L (2007)
2. Enter the appropriate password from the tables and click OK.
3. The vehicle battery voltage is checked to make sure it is at least 12 volts to assure reliable update results. Click OK if the results indicate Voltage is
OK.
NOTE:
If voltage is below 12 volts, click Cancel and then run the engine to assure an adequate battery charge state for reliable update results.
4. Update will begin and the progress of the update will appear on the bar graph.
5. Updating will occur until 100% is reached on the bar graph. Turn the ignition key OFF for 10 seconds, place it back in the ON position and then
click OK to continue according to Information displayed on the screen.
6. Click OK on the final screen, which indicates update is complete.
7. Check if any incidental Diagnostic Trouble Codes (DTC) have been created by the update and clear all DTC (5) present.
8. Start the engine to confirm proper operation of the vehicle.
WARRANTY CLAIM INFORMATION:
