Santa Fe FWD V6-2.7L (2007)
12. Click OK on the final screen, which indicates update is complete.
13. For EN Veracruz, after the update is completed, perform the VIN writing procedure or immobilizer key teaching procedure on affected vehicles
where it is referenced in the "3. ECM ROM ID INFORMATION " table earlier in this TSB.
14. Check if any incidental Diagnostic Trouble Codes (DTC) have been created by the update and clear the DTC (s) present.
15. Start the engine to confirm proper operation of the vehicle.
MANUAL UPDATE PROCEDURE USING THE GDS
CAUTION:
^
Manual update should be performed only if automatic update fails.
1. For vehicles using K-line as a communication interface between ECM and GDS,pull out the ECM fuse from the engine compartment junction box or
disconnect the battery negative cable to reset the control unit before performing manual update. Turn the ignition key back to the ON position. For
vehicles using CAN bus, turn off the ignition key for 10 seconds and then turn it back on to reset the ECM.
