Santa Fe FWD V6-2.7L (2007)
8. Clean the newly supplied plastic washer and apply grease to the washer as shown in the picture below. This will keep the washer in place during
re-installation.
NOTE:
Be careful not to apply excessive amounts of grease in this area. Grease is only used to keep the washer in place during re-installation.
9. Center the washer on the front hub, with its surface where grease has been applied facing the front hub, and then fix it to the front hub.
10. Repeat steps 1 through 8 on the other side and install all the removed parts in reverse order of removal.
NOTE:
When installing the driveshaft to the front hub be careful not to allow the washer to move. NOTE: Discard used/removed cotter pin and replace with
a new one. Do not reuse removed cotter pins during the re-installation process.
PART INFORMATION
WARRANTY INFORMATION