Santa Fe FWD V6-2.7L (2007)
1.
Following the diagnostic procedures outlined in the 2007 Santa Fe Shop Manual, measure the voltage between terminal 16 (LH FIS - B1327) or
terminal 17 (RH FIS - B1332) of the SRSCM connector and chassis ground. If it is NOT 0 V, disconnect the U/H-B connector at the underhood
junction box and re-check the voltage.
2.
Is the measurement 0 V?
If YES, continue to step 3.
If NO, locate and correct the short to battery on the harness between the SRSCM connector and underhood junction box connector, U/H-B.
Procedure complete.