Santa Fe FWD V6-2.7L (2007)
Tire Pressure Module: Service and Repair
TPMS RECEIVER
REPLACEMENT
NOTE: When the receiver first arrives for replacements.
a. It will be in Virgin State.
b. It will not be configured for any specific platform.
c. It will not have any sensor ID's memorized.
CAUTION: It is important to make sure that the correct receiver is used to replace the malfunctioning part i.e. High Line: 95800-4D100 in
order to have the correct inflation warning thresholds set.
1. Disconnect vehicle battery.
2. Remove malfunctioning part and fit bracket assembly to new part.
3. Secure new part to vehicle and fit connector.
4. Re-connect battery and turn Ignition on.
5. Check that TPMS lamp flash rate matches Virgin State indication.
6. Connect "TPMS exciter" to the diagnostic connector.
