Santa Fe FWD V6-2.7L (2007)
2. Draw a line (D) at a point, 3mm from the end of the knuckle stop (C), with a sharpened tool as shown in the drawing.
3. Grind the end of the knuckle stop to the line marked in step B2.
WARNING: Be sure to wear protective goggles when grinding.
CAUTION: Make sure to keep the specified grinding length. If not, the knuckle stop may not function properly.
CAUTION: Do not damage other components.
4. Test drive the vehicle according to step 1) to verify that no contact noise occurs.
WARRANTY INFORMATION:
