Santa Fe FWD V6-2.7L (2007)
CAUTION: The gas coming out is harmless, but be careful of chips that may fly up when drilling. Be sure to use face shield and safety
goggles.
INSTALLATION
1. Support the rear lower arm with a jack as shown in the illustration.
2. Install the rear shock absorber (A).
NOTE: After checking the distance (465± 10mm (18.31 ±0.39in))between the wheel housing garnish (A) and the hub assembly (B) as shown in
the illustration tighten the mounting bolts and nuts of rear chassis part with specified torque.
