Santa Fe FWD V6-2.7L (2007)
2. Remove the both boot clamps from the transaxle side PTJ case.
1) Using a flat-tipped (-) screwdriver, remove the both clamps of the transaxle side.
3. Pull out the boot from the transaxle side joint (PTJ).
4. Remove the clip (C) from the PTJ case (B).
5. While dividing joint (PTJ) boot (A) of the transaxle side, wipe the grease in PTJ case (B) and collect them respectively
CAUTION:
^
Be careful not to damage the boot.
^
According to below the illustrated, put marks (D) on roller of trunnion assembly (A), PTJ case (B) and spline part (C), for providing
assembly.