Santa Fe FWD V6-3.3L (2009)
Water Pump: Service and Repair
Repair Procedures
Removal
Water Pump
1. Drain the engine coolant.
WARNING:
System is under high pressure when the engine is hot. To avoid danger of releasing scalding engine coolant, remove the cap only when the engine
is cool.
2. Remove drive belt(A).
3. Remove the 4 bolts and pump pulley(A).
4. Remove the water pump(A) and gasket.
Installation
Water Pump
1. Install the water pump(A) and a new gasket(B) with 12 bolts. Apply sealant on C.
Tightening torque
21.56 - 23.52Nm (2.2 - 2.4kgf.m, 15.91 - 17.36lb-ft)
9.80 - 11.76Nm (1.0 - 1.2kgf.m, 7.23 - 8.68lb-ft)
Sealant : Three board 13868 or 13860