Santa Fe FWD V6-3.3L (2009)
29. Install the drive belt (A).
Crankshaft pulley -> A/C pulley -> idler pulley -> alternator pulley -> water pump pulley -> P/S pump pulley-> tensioner pulley.
Rotate auto tensioner arm in the counterclockwise moving auto tensioner pulley bolt with wrench.
After putting belt on auto tensioner pulley, release the auto tensioner pulley slowly.
30. Install the cylinder head cover.
(1) The hardening sealant located on the upper area between timing chain cover and cylinder head should be removed before assembling cylinder
head cover.
(2) After applying sealant (TB1217H), it should be assembled within 5 minutes.
Bead width:
2.5mm(0.1in.)
(3) The firing and/or blow out test should not be performed within 30 minutes after the cylinder head cover was assembled.
(4) Install the cylinder head cover bolts as following method.
Tightening torque :
9.80 - 11.76N.m (1.0 - 1.2kgf.m, 7.23 - 8.68lb-ft)
CAUTION:
Do not reuse cylinder head cover gasket.
(5) Install the ignition coil.
(6) Connect the RH ignition coil connector (A), the condenser connector (B) and install the wiring bracket (C).
