Santa Fe FWD V6-3.3L (2009)
3. The vehicle battery voltage is checked to make sure it is at least 12 volts to ensure reliable update results. Click OK if the results indicate Voltage is
OK.
NOTE:
If voltage is below 12 volts, click Cancel and then run the engine to ensure an adequate battery charge state for reliable update results.
4. Update will begin and the progress of the update will appear on the bar graph.
5. Updating will occur until 100% is reached on the bar graph. Turn the ignition key OFF for 10 seconds, place it back in the ON position and then click
OK to continue according to Information displayed on the screen.
6. Click OK on the final screen, which indicates update is complete.
7. Check if any incidental Diagnostic Trouble Codes (DTC) have been created by the upgrade and clear the DTC (s) present.
CAUTION:
There are 2 ROM-ID of the 2008MY Sonata ROM-ID table that require VIN write after the reflash. DTC P0630 may set for a No VIN error. Perform
the VIN write and clear the DTC after.
8. Start the engine to confirm proper operation of the vehicle.
