Santa Fe FWD V6-3.3L (2009)
11. Check for any diagnostic trouble codes (DTC) and erase the DTC(s) present.
12. Start the engine to confirm proper operation of the vehicle.
C. MANUAL UPDATE PROCEDURE
CAUTION:
Manual update should be performed only if automatic update fails.
1. Turn the ignition key to the OFF position, pull out the PCM (ECM) fuse from the engine compartment junction box or disconnect the battery negative
cable to reset the control unit before performing manual update. Turn the ignition key back to the ON position.
2. Within the ECU Upgrade screen, select Manual Mode in the left column, then select the appropriate update event:
^
Update Event #132 for 2006-2007 EP Entourage
^
Update Event #126 for 2007 CM Santa Fe 3.3L (K-Line)
^
Update Event #128 for 2008-2009 CM Santa Fe 3.3L (CAN)
3. Select the appropriate control unit part number with reference to the above ROM ID Information Table and click OK
