Santa Fe FWD V6-3.3L (2009)
13. Check if any incidental Diagnostic Trouble Codes (DTC) have been created by the update and clear the DTC (s) present.
14. Start the engine to confirm proper operation of the vehicle.
MANUAL UPDATE PROCEDURE USING THE GDS:
CAUTION:
^ Manual update should be performed only when automatic update fails after the ECM update had begun showing the progress bar.
^ Pull out the ECM fuse from the engine compartment junction box or disconnect the battery negative cable for at least one minute to reset the control
unit before performing manual upgrade. Turn the ignition key back to the ON position.
^ If neither of the above works disconnect the connectors from the ECM for 10 minutes and try again.
1. Within the ECU Upgrade screen, select Manual Mode in the left column, then select the appropriate upgrade event# from the below table. Select the
appropriate control unit part number with reference to the ROM ID Information Table and click OK.
CAUTION:
Be sure to select NON IMMO part number for the correct vehicle as Santa Fe and Sonata vehicles in USA do not have immobilizer.
2. Enter the appropriate password from the tables below and click OK.
