Santa Fe FWD V6-3.3L (2009)
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the rear seat.
3. Disconnect the side impact sensor connector.
4. Loosen the side impact sensor mounting bolt and remove the side impact sensor.
Installation
Front Side Impact Sensor
CAUTION:
-
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.
Tightening torque
: 0.7 - 0.9 kgf.m (6.8 - 9.2 Nm, 5.0 - 6.8 lb.ft)
2. Install the center pillar trim.
3. Install the door scuff trim.
4. Reconnect the battery negative cable.
5. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on
for about six seconds and then go off.
Rear Side Impact Sensor
CAUTION:
-
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.
Tightening torque
: 0.7 - 0.9 kgf.m (6.8 - 9.2 Nm, 5.0 - 6.8 lb.ft)
2. Install the rear seat.
3. Reconnect the battery negative cable.
4. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on
for about six seconds and then go off.