Santa Fe FWD V6-3.3L (2009)
Repair procedures
Removal
1. Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2. Remove the rear wheel and tire (A) from the rear hub (B).
CAUTION:
Be careful not to damage to the hub bolts (C) when removing the rear wheel and tire (A).
3. Remove the split pin (A), then remove castle nut (B) and washer (C) from the front hub under applying the brake.
4. Remove the mounting bolt (B) of the rear lower arm (A) and the rear carrier, while supporting the lower arm (A) with a jack as shown in the
illustration. Loosen the mounting bolt (C) of the cross member and the rear lower arm.
