Scoupe L4-1468cc 1.5L SOHC VIN J MFI (1994)
4.
Install the new EPROM carefully with the notch in the EPROM matching the notch in the socket. Use extreme caution not to bend the pins of the
EPROM. Reinstall the white retainer.
5.
Place the cover over the base. Turn the ECM upside down and bend the ten tabs down to fasten the base to the cover.
6.
Install the ECM into the vehicle.
7.
Open the left door and place a punch mark over the 11th character on the B-Pillar identification plate. This will indicate that the campaign
procedures have been completed.
Turbocharged
1.
Disconnect the negative battery cable. Remove the Engine Control Module (ECM) from the vehicle following the instructions in the Shop Manual.
2.
With the bottom side up on the ECM, bend the ten tabs straight up to release the cover from the base and separate. Be sure to retain the plastic
shield for reassembly.
3.
Use a pliers to remove the retaining pin, located on the bottom of the ECM.
