Scoupe L4-1468cc 1.5L SOHC VIN J MFI (1994)
Stabilizer Link: Service and Repair
1. Raise and support front of, vehicle, then remove wheel and tire assembly.
2. Using tie rod end puller tool No. 09568-31000, or equivalent, separate tie rod end from steering knuckle.
3. Remove rear roll stopper mounting bolt and rear roll bracket mounting bolt. Pull rear roll bracket assembly forward. Do not disconnect center
member assembly.
Fig. 11 Stabilizer Bar Replacement
4. Loosen stabilizer link bolt and nut, then disconnect stabilizer bar from lower control arm,Fig. 11.
5. Loosen stabilizer bar mounting bolts through access holes provided in body.
6. Remove stabilizer bar through access opening.
7. Reverse procedure to install.
