Sonata L4-2.0L (1992)
Downshift Switch: Testing and Inspection
Accelerator Switch
1.After warming up the engine confirm that the accelerator switch is on with the accelerator pedal in the free state.
NOTE: Check that the accelerator switch is on or off by chekcing the voltage between the G wire and the ground wire at the accelerator switch
connector (2 pin).
Switch on: 0 Volts
Switch off: 12 Volts
2.Measure stroke A, shown in the illustration of the accelerator pedal, at the point where the accelerator switch goes from on to off when the pedal is
depressed.
Standard value: 4-8 mm (0.16-0.31 in)
If stroke A is not within the standard value adjust the accelerator switch.
