Sonata V6-2.7L (2004)
4) Select air bleeding mode.
5) Press "YES" to operate motor pump and solenoid valve.
6) "ON" and "OFF" control are automatically performed to prevent the motor pump from being burnt. (If not, you may damage the motor).
5. Pump the brake pedal several times, and then loosen the bleeder screw until fluid starts to run out without bubbles. Then close the bleeder screw.
6. Repeat the step 5 until there are no more bubbles in the fluid for each wheel in the sequence shown in the illustration.
7. Tighten the bleeder screw.
Bleeder screw tightening torque: 7 - 13 Nm (70 - 130 kgf-cm, 5.2 - 9.6 ft. lbs.)
