Sonata V6-2.7L (2004)
8. Connect the scan tool to the data link connector in the fuse box.
9. If the scan tool is not used, connect a voltmeter between throttle position sensor connector terminals 1 (sensor ground) and 3 (sensor output) using
pin.
NOTE:
-
Do not disconnect the TP Sensor connector.
-
Use a digital type voltmeter to obtain an accurate value.
10. Turn the ignition switch "ON."
NOTE: Do not start the engine.
11. Check the throttle position sensor output voltage.
Throttle position sensor output voltage :250-800 mV
12. If the voltage is out of specification, check the throttle position sensor and associated harnesses.
13. Remove the feeler gauge.
14. Turn the ignition switch OFF
