hyundai Workshop Repair Guides

Hyundai Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 2001 > < Diagram Information and Instructions|Page 1999
Page 3
background image

Second alarm condition during alarming. When another alarm occurs during alarming, the starting is disabled, and the alarm continues to
sound for the remained time of warning signal. The alarm continues to sound after the second alarm condition is removed. New alarm
condition occurs after alarming (with all entrances closed) If any entrance is opened again then
-

The siren is ON 3 times

-

Start is disabled

-

Hazard lamps flash during the ON time of siren

New alarm condition occur after alarming (with any entrance open).

If another entrance is opened, the ETACS module keeps start disabled and there is no siren output.

3. Key operation during alarm

After the alarm state or start inhibit state are entered, if door warning switch on (key in ignition) & IGN 2 ON, if IGN 2 state is changed to
OFF within 30 sec, remain in alarm state.

4. Disarming using the key

During alarming, in case that door warning switch (key in) is ON and then IGN1 and IGN2 are both ON for 30 sec continuously, the alarm is
cancelled, and the system enters the disarm state. After alarming, in case that door warning switch (key in) is ON and then IGN1 and IGN2 are
both ON for 30 sec continuously, the alarm is cancelled, and the system enters the disarm state.

5. ALARM STATE IN POWER DOWN

Diagram Information and Instructions|Page 2001 > < Diagram Information and Instructions|Page 1999