Sonata V6-2.7L (2004)
Starter Armature: Testing and Inspection
ARMATURE INSPECTION AND TEST
1. Remove the starter.
2. Disassemble the starter as shown at the beginning of this procedure.
3. Inspect the armature for wear or damage from contact with the permanent magnet. If there is wear or damage, replace the armature.
4. Check the commutator (A) surface. If the surface is dirty or burnt, resurface with emery cloth or a lathe within the following specifications, or
recondition with #500 or #600 sandpaper (B).
5. Check the commutator diameter. If the diameter is below the service limit, replace the armature.
Commutator diameter
Standard (New):
M/T: 29.9 - 30.0 mm (1.177-1.181 in.)
A/T: 28.0 - 28.1 mm (1.102-1.106 in.)
Service limit:
M/T: 29.0 mm (1.142 in.)
A/T: 27.5 mm (1.083 in.)
