Sonata V6-3.0L (1991)
Use the following steps to machine an "Inside of Hub" disc attachment design:
1.
Confirm that the "off-car lathe" has a spindle arm holding fixture.
Note:
If your "off-car lathe" doesn't have the spindle arm fixture, use Service Procedure 3 for machining the disc.
2.
Remove hub and knuckle assembly from the vehicle per procedure outlined in the appropriate Shop Manual.
Note:
Do not use a "slide hammer" to remove the hub assembly. This may damage the wheel bearings.
3.
Mount the knuckle assembly with the disc on the "off-car lathe" (see illustration above).
4.
Machine the disc on the "off-car lathe" following the lathe manufacturer's instructions. (See appropriate Shop Manual for service limit
specification.)
5.
Reinstall the hub and knuckle assembly on the vehicle.
6.
Repeat procedure for other side.
Service Procedure 2B (Sonata model):
Use the following steps to machine an "Outside of Hub" disc attachment design.
1.
Remove the disc from the vehicle per procedure outlined in the appropriate Shop Manual.
2.
Mount the disc on the "off-car lathe".
3.
Machine the disc on the "off-car lathe" following the lathe manufacturer's instructions. (See appropriate Shop Manual for service limit
specification.)
4.
Reinstall the disc on the vehicle.
5.
Repeat procedure for other side.
SERVICE PROCEDURE 3 (Excel, Scoupe, Accent, Elantra & Tiburon):
Note:
Use Service Procedure 3 ONLY if Service Procedures 1 & 2A are not available.
1.
Remove hub and knuckle assembly from the vehicle per procedure outlined in the appropriate Shop Manual.
2.
Separate disc from knuckle and hub assembly per procedure outlined in the appropriate Shop Manual.
Note:
Do not use a "slide hammer" to remove the hub assembly from the knuckle assembly. This procedure may damage the wheel bearings.
3.
Machine the disc on the off-car lathe following the lathe manufacturer's instructions.
4.
Reinstall the disc on the hub and knuckle assembly.
5.
Reinstall the hub and knuckle assembly on the vehicle.
6.
Repeat procedure for other side.
WARRANTY INFORMATION:
Normal warranty operation codes and times apply.
